2017 Yamaha R6 Bike was purchased and built from mile zero and located in Salt Lake City, UT. https://www.facebook.com/motostationslc/posts/2137625189702115 Engine/Powerplant: Brand new engine built in 2019 Engine build is all stock internals with 2mm pistons. Makes 138-140hp on a MR12 fuel. Graves full Ti Carbon exhaust system Older/Preferred air box MWR air filter Febur SBK radiatorSamco hose kit Motion Pro coolant reservoir GB Racing engine guards Graves CCT Electronics: FTECU Race Team electronics suite (Active Tune, QS, Autoblip, race harness, ABS delete) Button pod on left side handlebar to control TC+/- Button pod on right side control fuel map, launch control, kill switch Speedcell ignition switch Bespoke ‘kit’ charging system Speedcell 8cell battery with aux. Anderson connector under subframe for support battery Brakes: Galespeed 18mm billet master cylinder Spiegler front and rear brake lines Galfer SBK rotors Galfer 1303 front pads Captive Rear caliper setup Controls: Attack Performance zero offset clip-ons with Renthal tubes Attack Performance rearsets Galespeed clutch lever assy. Graves front brake lever guard Suspension: GP Suspension 25mm carts GP Suspension fork extender caps Race Tech G3-S shock Ohlins steering damper with Graves mount Final Drive: Drive Systems sprockets DiD ERV3 chain Ceramic wheel bearings Captive wheel spacers Chassis: Graves diamond frame sliders Graves shark guard DB Holders subframe Lightech Fuel cap Graves progressive throttle tube Bodywork: Taylormade bodywork Taylormade seat pan with Graves neoprene pad Custom tank support Zero Gravity Corsa windscreen Graves bodywork mount kit Graves seat mounts Additional/Spares that could be worked into the purchase: Graves pit stop race stand Rear sprocket gearing Spare wheel set (rotors, spacers, etc.)
SOLD. If you're looking for a killer R6, check this one out: http://forums.13x.com/index.php?threads/yamaha-r6-2017-18-will-ship-to-lower-48.370696/#post-5802823
Stand not for sale. I used a 3d scanner to scan the r6 tank to get the shape. Then I used cad to design the cover and 3d printed it. We tried 4 versions of the cover before we got it right. Fun project.
Good think Blue Junk is here. The tank cover is a Moto Station team product. Ultimately up to him if they're for sale.
